Inserting Deck Screws into Luan Plywood Flooring

Inserting Deck Screws into Luan Plywood Flooring

Quarter-inch lauan plywood is the top material for underlayment among home renovators and contractors. It's quality is unsurpassed, and it is extremly durable and long-lasting. Amoung Manufactuers of Vinyl Flooring, Hardwood Flooring, Tile Flooring, and Laminate Flooring, the choice is clear, and Luan is the top pick. Of course before you proceed with any home improvement product, you should check with your flooring manufacturer before you proceed with installation to confirm.

How to Bend Plywood

There are two types of Luan:

Luan Type 1 with an exterior glue, is the more resistant to delamination, and should be installed under very durable flooring

 Luan Type 2 with a water-resistant glue.


The type is normally indicated on the panal edge. Usually on the 4 foot edge, on the 4x8 sheet. There are three possible standards of Luan, which are

BB -  the highest grade and should be used whenever possible.

CC

OVL (Overlay)

APA’s installation guidelines for 1/4-inch plywood should be followed when installing lauan plywood, but installers BEWARE: Lauan is made under a wall-panel specification of the International Hardwood Products Association (IHPA). No manufacturing specifications support its use or gauge its performance as an underlayment.

Installation Guide for Luan Wood

Using Luan Plywood as Flooring

Using Ceramic or Carpet Over Luan Wood

Removing Luan Plywood - Instructions

Using Luan Subfloor For Laminate

Using Staples to Install Luan Subfloor

How to Install Luan Wood on Curved Surfaces

How to Finish Luan Flooring

Attaching Luan Plywood to Subfloor

Using Luan Subfloor for Vinyl

Instructions for Applying Plywood to the Subfloor

Set the plywood to sit for several hours in the room in which will be installed

Make sure the subfloor is not wet and structuraly sound

Install with 1″ deck scews into sheet of plywood, smooth side facing upward

Make sure the underlayment sems are not aligned with the subfloor seams

Lay the following plywood sheet – start along the longest wall and leave 1/4″ expansion gaps in between sheets and between the sheets the walls

Secure the plywood sheet every 6″ – make sure to drive the deck screw heads bellow the surface of the plywood sheet

Cut the plywood shets as required to follow the surface of the floor

Apply floor patching over the screw heads and the plywood seams

After the patching compound has dried, sand the compound

Vaccum and wipe with a damp cloth all the resulting dust